How to Program a Garage Door Opener

These days, people rely on universal remotes to open and close their garage doors. Some are even capable of doing it from a remote in their vehicles. The process of picking out a garage door and getting it installed is a bit hefty and lengthy, but a new door is well worth the time spent.  Once everything is installed, you must then learn how to program a carport door opener. This article will highlight the steps needed to begin operating the remote control for the garage.

How to Program Replacement Garage Door Opener

Programming the Remote Control

If you are only interested in programming a universal remote to have around and about, they are set up a little bit differently from one utilized in a car. Firstly, you’ll need to press and hold the two outside buttons on the universal remotes until a red light is blinking on it. Now, choose which button you’d prefer to open the door with then choose the closing button.

Should I buy a keypad to program to the Garage Door?

The short answer is YES! I cannot tell you how many times I have forgotten my remote somewhere and could not get inside the garage without a keypad. I used the universal garage door keypad reviews site to find one that would work for my brand of opener.

Programming a Universal Remote

Each universal remote comes with a manual filled with garage door brands and codes to connect the remote to. Since each opener is designed differently, you’ll need to press the buttons a certain amount or for a particular length of time for it to properly connect to that specific branded opener. As an example, a brand may require that you hold down the on button for about 5 seconds or to press the button about three times. After the code has been inputted, you’ll need to press down the button you chose for the opening purposes until that red light from before appears again.

To complete the programming, all that is left to do is determine whether the opener has a smart button or a couple of code switches. You can recognize the smart button near the light lens on the back side of your garage door motor. If it is, the final part is simple.Press the smart button of the garage motor and the remote simultaneously for about three seconds and release them both. Most of the newer units come installed with smart button, and switches are rarely used anymore. More than likely this will finalize the programming process. However, if your remote has switches, it’s a little different. Simply input the nine-digit code listed on the garage opener motor and wait for the red light to come on. Once you the red light comes on, voila, the programming is completed.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>